Technical data
Table Of Contents
- E60 M5
- System overview
- Foreword
- Purpose of this Participant's Manual
- Introduction
- S85B50
- Basic engine and add-on parts
- Upper section of crankcase
- Bedplate
- Crankcase
- Cylinder head
- Crankshaft/main bearings
- Connecting rods
- Pistons
- Camshaft
- Valve springs
- Valve cotters
- Box-type tappets
- Valves
- VANOS High pressure pump
- VANOS Actuators
- VANOS gear mechanism
- VANOS Pressure accumulator
- Oil pumps
- Electric oil pumps
- Oil spray nozzles
- Oil filter housing
- Exhaust manifold
- Intake air manifold
- Intake silencers
- Radiator
- Thermostat
- Objectives
- Purpose of this Participant's Manual
- Introduction
- Functional Principle of the Digital Motor Electronics
- Digital Motor Electronics (DME)
- DME control unit Siemens MS_S65
- Hot-film air mass meter (HFM)
- Fuel pressure sensor
- Electric fuel pump (EKP)
- EKP module
- Ionic current control unit
- Crankshaft sensor
- Camshaft sensor
- Oil condition sensor (QLT)
- Oil pressure switch
- Oil extraction pump
- Idle speed actuator (LLS)
- Throttle valve actuator motor
- Throttle valve sensor (DKG)
- Secondary air pump
- Mini HFM for secondary air system
- Primary oxygen sensor (control sensor)
- Secondary oxygen sensor (monitor sensor)
- Exhaust gas temperature sensor
- Pressure accumulator shut-off valve (VANOS)
- Service information
- Objectives
- Purpose of this Participant's Manual
- New 7-speed SMG
- The new SMG3
- Special functions
- Transmission ratio of the SMG3
- Gearshift pattern
- Signals and parameters
- Hydraulic system
- Initialization
- Purpose of this Participant's Manual
- MK60E5 from Continental Teves
- Further development of the MK60psi
- DSC Additional Functions
- Differences compared to the MK60psi
- Purpose of this Participant's Manual
- Additional Functions
- Differences compared to the E60
- Displays and indicators in the E60 M5
5
8
System overview
Displays, Indicators and Controls
Differences compared to the E60
The M5 instrument cluster is based on the
instrument cluster of the E60 545i. The
changes to the visual appearance and the
additional functions are described in detail in
the chapter System Components.
The head-up display (HUD) has been adopted
from the E60 as the additional functions relate
to the HUD software.
The "M-Drive" menu item in the central
information display (CID) has been created
simply by corresponding software
adaptations.
The M-Drive settings are stored key-specific
in the engine management and are called up
accordingly. The engine management can
store up to 10 different settings in the
memory.