User Guide

61.20
Replacing side stand switch
Removing and installing side stand
switch
•
Disconnect plug (arrow).
•
Open the cable ties.
e Caution:
Screw is secured with thread-locking compound.
•
Release the fastener (arrow).
•
Remove side stand switch with cable.
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e Caution:
Install screw and nut with Loctite 243.
L Note:
When installing, note the correct positions of the ca-
ble straps.
X Tightening torques:
Side stand switch fastener ............................. 7 Nm
(clean thread + Loctite 243)
Check operation of side stand switch
•
Switch off the engine.
•
Place motorcycle on its centre stand.
•
Select a gear and switch on the ignition.
– Temperature gauge warning lamp lights up.
•
Extend the side stand, observing the tempera-
ture gauge warning lamp.
– Temperature gauge warning lamp goes out (en-
gine control unit switches off).
KL610080
KR610360