User Guide

61.18
Removing and installing control
unit for reverser
– Remove left side section of fairing.
a ....................................................See Group 46
– Remove the rear left footrest plate.
– Remove the left-hand battery cover.
– Remove rear seat.
e Caution:
To avoid short-circuits: Disconnect negative battery
lead (—) first, then positive (+) lead.
– Remove the battery.
•
Open the cable ties (arrows).
•
Disconnect plugs (1, 2).
•
Disconnect cables at terminals for starter
motor (3) and ground (4) on the frame.
•
Disconnect cables of control unit at terminals
for starter motor and ground.
•
Disconnect plug at ABS control unit.
•
Remove fasteners securing coolant expansion
tank.
•
Pull cables through toward control unit.
•
Release the fastener (5).
•
Remove control unit.
•
Installation is the reverse of the removal proce-
dure.
KL610220
x
4
2
3
1
KL610230
5