User Guide

16.7
Removing/installing fuel filter
•
Open clips (4, 7).
•
Disconnect fuel hoses (3, 8) from fuel filter (5).
e Caution:
Note correct direction of flow through fuel filter.
•
Connect fuel hoses (3, 8) to new fuel filter (5).
•
Close clips (4, 7) with pliers, BMW No. 13 1 500.
Removing/installing fuel pump
•
Detach connecting cables (1, 2) from fuel pump.
•
Open hose clip (9) and disconnect hose (8).
•
Release holder (13).
•
Release vibration damper at pump outlet (14).
•
Pull fuel pump (12) with pump inlet vibration
damper (11) off holder (6).
•
Pull pump inlet vibration damper (11) off fuel
pump (12).
•
If necessary, pry off intake filter (10).
•
Installation is the reverse of the removal proce-
dure: pay particular attention to the following.
e Caution:
Position of intake filter (10): do not damage the filter.
Installing the fuel-pump unit
•
Install the fuel-pump unit complete with seal in
the fuel tank.
L Note:
Make sure that the arrow on the underside of the
fuel tank points directly toward the arrows on the
fuel-pump unit.
•
Tighten the union nut with wrench,
BMWNo.161710.
•
Install the fuel tank.
X Tightening torques:
Union nut ..................................................... 30 Nm
Fuel tank to frame M 8 ................................. 21 Nm
Bridge to frame M 8 ..................................... 21 Nm
Bridge to frame M 6 ....................................... 9 Nm
KL160023
7
1
10
4
8
2
3
6
12
9
13
14
5
11
KL160024