Operation Manual

Confirmation tone sounds
twice (if programmed).
Anti-theft alarm is active.
To deactivate the motion
sensor (for example if you
are about to transport the
motorcycle on a train and the
swaying movement of the
moving train could trip the
alarm), press button 1 on the
remote control again during the
activation phase.
Turn indicators flash three
times.
Confirmation tone sounds three
times (if programmed).
Motion sensor is deactivated.
Alarm
with anti-theft alarm (DWA)
OE
An alarm can be triggered by
the motion sensor
an attempt to use an unau-
thorised key to switch on the
ignition
disconnection of the anti-theft
alarm from the motorcycle's
battery (internal battery in the
anti-theft alarm provides power
- alarm tone only, the turn in-
dicators do not flash)
All functions are sustained even if
the internal battery of the anti-
theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. You
can program the type of alarm
tone.
with central locking
OE
You can cancel an alarm at any
time without deactivating the
anti-theft alarm by pressing but-
ton 2 on the remote control.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
4
72
z Operation