Operation Manual

Place the motorcycle on its
centre stand or another auxiliary
stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Use basic stand with tool num-
ber (83 30 0 402 241) in com-
bination with front-wheel ad-
apter (83 30 0 402 243).
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Slacken adjusting screws 1.
Push the two pins 2 apart un-
til the front suspension fits
between them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
There is a risk of damaging
the sensor ring of the BMW
Motorrad Integral ABS.
Push the left pin in just far
enough to ensure that it clears
the sensor ring.
Push both mounting pins 2
through the triangles of the
brake caliper anchorages just
far enough to allow the front
wheel to be rolled between
them.
Tighten adjusting screws 1.
If the motorcycle is on the
centre stand and is raised
too far, the centre stand will lift
clear of the ground and the mo-
torcycle could topple to one side.
When raising the motorcycle,
make sure that the centre stand
remains on the ground.
8
129
z Maintenance