Operation Manual

Hold the front-wheel cover in
position and install bolts 1 on
left and right.
Remove the rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
If applicable, remove the cases.
Remove screws 1 on left and
right.
Remove the number-plate car-
rier.
Engage first gear.
Risk of burns caused by the
hot exhaust system.
Do not touch the exhaust system
when it is hot; if necessary, allow
the exhaust system ample time
to cool before proceeding.
Remove five bolts 1 from the
rear wheel, while supporting
the wheel.
Lower the rear wheel to the
ground and roll it out to the
rear.
8
127
z Maintenance