Operation Manual

Insert the ABS sensor into its
bore and install screw 1.
Ease the brake calipers on to
the brake discs.
Install securing screws 3 on
left and right and tighten to
specified tightening torque.
Front brake caliper to
wheel carrier
30 Nm
Clip retaining clip 1 of the
sensor cable to the brake line.
Secure new cable tie 2.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
8
126
z Maintenance