Operation Manual

If the front wheel lifts clear of the
ground under severe accelera-
tion, ASC reduces engine torque
until the front wheel regains con-
tact with the ground.
Under these circumstances,
BMW Motorrad recommends
rolling the throttle slightly closed
so as to restore stability with the
least possible delay.
When riding on a slippery sur-
face, never snap the throttle
twistgrip fully closed without
pulling the clutch at the same
time. Engine braking torque can
cause the rear wheel to lock, with
a corresponding loss of stability.
The BMW Motorrad ASC is un-
able to control a situation of this
nature.
Tyre pressure
monitoring RDC
with tyre pressure monitoring
(RDC)
OE
Function
A sensor integrated into each
tyre measures the air tempera-
ture and the air pressure inside
the tyre and transmits this in-
formation to the control unit.
Each sensor has a centrifugal-
force tripswitch that does not
enable transmission of the meas-
ured values until the vehicle has
accelerated to about 30 km/h.
The display shows -- for each
tyre until the tyre-pressure signal
is received for the first time. The
sensors continue to transmit the
measured-value signals for ap-
proximately 15 minutes after the
motorcycle comes to a stop.
Tyre-pressure ranges
The RDC control unit differenti-
ates between three tyre-pressure
ranges, all of which are paramet-
erised for the motorcycle:
Tyre pressure within permitted
tolerance.
Tyre pressure close to limit of
permitted tolerance.
Tyre pressure outside permit-
ted tolerance.
Temperature
compensation
Tyre pressure is a temperature-
sensitive variable: pressure in-
creases as tyre temperature rises
and decreases as tyre temper-
ature drops. Tyre temperature
depends on ambient tempera-
ture, on the style of riding and
the duration of the ride.
7
92
z Engineering details