Operation Manual

Adjust the damping for
rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Adjust the damping character-
istic, using the tool from the
on-board toolkit to turn adjust-
ing screw 1.
If you want a harder damping
characteristic, turn adjusting
screw 1 in the direction indic-
ated by the H arrow.
If you want a softer damping
characteristic, turn adjusting
screw 1 in the direction indic-
ated by the S arrow.
Basic setting of rear-
suspension damping
characteristic
without Electronic
Suspension Adjustment
(ESA II)
OE
Basic setting of rear-
suspension damping
characteristic
Turn the adjusting screw as
far as it will go in the direction
indicated by the H arrow and
then turn it back one and a
half turns in the direction in-
dicated by the S arrow. (Full
load of fuel, with rider 85 kg)
Electronic Suspension
Adjustment ESA
with Electronic Suspension Ad-
justment (ESA II)
OE
Settings
Electronic Suspension Adjust-
ment ESA provides a convenient
way of adapting the motorcycle
to the load it carries and the sur-
face over which you intend riding.
You have a choice of three load
modes with any of three damp-
4
58
z Operation