Operation Manual

Remove screw 1 while
counter-holding sleeve nut 2.
Hold the peg in the desired
position and tighten screw 1 to
the specified tightening torque.
In this process, counter-hold
sleeve nut 2.
Peg to footbrake lever
with HP footrest system
OA
10 Nm
Adjusting footbrake lever
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw 1.
Hold peg 2 in the desired posi-
tion and tighten screw 1 to the
specified tightening torque.
Peg to footbrake lever
with HP footrest system
OA
10 Nm
Mirrors
Adjusting mirrors
Pivot the mirror to the correct
position by pressing gently at
the edge.
Spring preload
Adjustment
It is essential to set spring pre-
load of the rear suspension to
suit the load carried by the mo-
torcycle. Increase spring pre-
load when the vehicle is heavily
loaded and reduce spring preload
4
56
z Operation