Operation Manual

Low-beam headlight
The low-beam headlight switches
on automatically when you start
the engine.
When the engine is not
running you can switch on
the lights by switching on the ig-
nition and either switching on the
high-beam headlight or operating
the headlight flasher.
High-beam headlight and
headlight flasher
Push switch 1 forward to
switch on the high-beam
headlight.
Pull switch 1 back to operate
the headlight flasher.
Parking lights
Switch off the ignition.
Immediately after switching off
the ignition, push button 1 to
the left and hold it in this po-
sition until the parking lights
come on.
Switch the ignition on and off
again to switch off the parking
lights.
Turn indicators
Operating the turn
indicators
Switch on the ignition.
The turn indicators are can-
celled automatically after
you have ridden for approximately
10 seconds and covered a dis-
tance of about 300 m.
Push button 1 to the left to
switch on the left turn indicat-
ors.
Push button 1 to the right to
switch on the right turn indicat-
ors.
4
49
z Operation