Operation Manual

the battery from the on-board
systems and connect the charger
directly to the battery.
Charging battery when
disconnected
Charge the battery using a
suitable charger.
Comply with the operating in-
structions of the charger.
Once the battery is fully
charged, disconnect the
charger's terminal clips from
the battery terminals.
The battery has to be re-
charged at regular intervals
in the course of a lengthy period
of disuse. See the instructions
for caring for your battery. Al-
ways fully recharge the battery
before restoring it to use.
Removing battery
Removing battery-compartment
cover ( 131).
with anti-theft alarm (DWA)
OE
If applicable, switch off the anti-
theft alarm.
Switch off the ignition.
Disconnection in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Disconnect negative lead 1
first.
Then disconnect positive
lead 2.
Remove screws 3 and pull the
retainer to the rear.
Lift the battery up and out;
work it slightly back and forth
if it is difficult to remove.
Installing battery
Place the battery in the battery
compartment, positive terminal
on the right in the forward dir-
ection of travel.
Slip the battery retainer
over the battery and install
screws 3.
9
130
z Maintenance