Operation Manual

Install screw 1.
Replacing rear turn
indicator bulbs
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove screw 1.
Pull the glass out of the
turn-indicator housing at the
threaded-fastener side.
Press bulb 2 into its socket
and turn it counter-clockwise to
remove.
Replace the defective bulb.
Bulbs for flashing turn
indicators, rear
R10W / 12 V / 10 W
Use a clean, dry cloth to hold
the new bulb in order to keep
the glass free of foreign matter.
9
126
z Maintenance