Operation Manual

Remove retaining disc 2. To
do so, press release button 3.
Make sure the ground is level
and firm and place the motor-
cycle on its side stand.
Push the rear wheel stand from
the left into the rear axle.
Push on retaining disc 2 from
the right, while holding the re-
lease button down.
Hold the motorcycle upright
and at the same time press the
handle of the stand back until
both rollers of the stand are on
the ground.
Then press the handle down to
the ground.
In order to ensure secure pos-
itioning, fit lever 4 to the short
side of the stand.
Bulbs
Replacing low-beam and
high-beam headlight bulb
The plug arrangement can
differ from the illustration,
depending on the bulb to be
replaced.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
9
121
z Maintenance