Operation Manual

There is a risk of dam-
aging the sensor ring of
the BMW Motorrad Integral ABS.
Push the left pin in just far
enough to ensure that it clears
the sensor ring.
Push both mounting pins 2
through the triangles of the
brake calliper anchorages just
far enough to allow the front
wheel to be rolled between
them.
Tighten adjusting screws 1.
If the motorcycle is on the
centre stand and is raised
too far, the centre stand will lift
clear of the ground and the mo-
torcycle could topple to one side.
When raising the vehicle, make
sure that the centre stand re-
mains on the ground.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
Rear-wheel stand
Installing rear-wheel
stand
Use basic stand with tool num-
ber (83 30 0 402 245) in com-
bination with rear-axle adapter
(83 30 0 402 250).
with K 1300 S special model
with HP package
OE
Proceed by analogy with the
description below to use the
auxiliary stand supplied.
Use screws 1 to set the rear-
wheel stand to the desired
height.
9
120
z Maintenance