Operation Manual

Hold the silencer cover 2
in position and install three
screws 1.
without centre stand generation
II
OA
Remove the rear-wheel stand
Front-wheel stand
Installing front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support motorcycles not fitted
with a centre stand or without
other auxiliary stands. A motor-
cycle resting only on the front
wheel stand and the rear wheel
can topple.
Place the motorcycle on its
centre stand or another auxiliary
stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Use basic stand with tool num-
ber (83 30 0 402 241) in com-
bination with front-wheel ad-
apter (83 30 0 402 243).
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
Install the rear-wheel stand
( 120).
with centre stand generation
II
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Loosen the fastening screws 1.
Push the two pins 2 apart un-
til the front suspension fits
between them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
9
119
z Maintenance