Operation Manual

Install securing screws 2 on
left and right and tighten to
specified tightening torque.
Front brake caliper to
wheel carrier
30 Nm
The cable of the wheel-
speed sensor could chafe
through if it comes into contact
with the brake disc.
Make sure that the sensor
cable is routed correctly.
Clip two retaining clips 1 of the
sensor cable to the brake line.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
until the pressure point is per-
ceptible, and repeat this opera-
tion several times.
Hold the front-wheel cover in
position and install bolts 1 on
left and right.
Removing rear wheel
Place the motorcycle
on an auxiliary stand;
BMW Motorrad recommends
the BMW Motorrad rear-wheel
stand.
Install the rear-wheel stand
( 120).
with centre stand generation
II
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
9
115
z Maintenance