Operation Manual

Brake-pad wear limit,
rear
min 1.0 mm (Friction pad only,
without backing plate. Make
sure that the brake disc is not
visible through the bore in the
inboard brake pad.)
If the brake disc is visible:
Brake pads worn past the
minimum permissible thick-
ness can cause a reduction in
braking efficiency and under
certain circumstances they can
cause damage to the brake sys-
tem.
In order to ensure the dependab-
ility of the brake system, do not
permit the brake pads to wear
past the minimum permissible
thickness.
Have the brake pads replaced
by a specialist workshop,
preferably an authorised
BMW Motorrad dealer.
Checking brake-fluid
level, front brakes
A low fluid level in the
brake reservoir can allow air
to penetrate the brake system.
This significantly reduces braking
efficiency.
Check the brake-fluid level at
regular intervals.
Make sure the ground is level
and firm and hold the motor-
cycle upright.
with centre stand generation
II
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Move the handlebars to the
straight-ahead position.
Check the brake fluid level in
brake fluid reservoir 1.
Wear of the brake pads
causes the brake fluid level
in the reservoir to sink.
9
107
z Maintenance