Operation Manual

handle of the stand back until
both rollers of the stand are on
the ground.
Then press the handle down to
the ground.
In order to ensure secure pos-
itioning, fit lever 4 to the short
side of the stand.
Bulbs
Replacing low-beam and
high-beam headlight bulb
The plug arrangement can
differ from the illustration,
depending on the bulb to be
replaced.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove the covers 1 for the
high-beam headlight or cover 2
for the low-beam headlight by
turning the covers anticlock-
wise.
Disconnect plug 3.
Disengage spring clip 4 from
the latches and swing it up.
Remove bulb 5.
8
105
z Maintenance