Technical data

bound) is displayed at posi-
tion 4 REB:.
Hold down button 2 until the
reading next to "REB:"/"COM:"
flashes.
Using buttons 1 and 2, adjust
damping as desired.
+1 .. +7: increase damping to
a maximum of seven levels
-1 .. -7: reduce damping to a
maximum of seven levels
0: default settings
Performing a zero position
alignment
Place the motorcycle on the
side stand or on a suitable aux-
iliary stand.
During the alignment, do not
sit on the motorcycle; remove
pieces of luggage.
To align the zero position, first
press buttons 1/2 until "DDC"
is displayed at position 3 and
"CAL" (Calibration) is displayed
at position 4.
Then press and hold down
button 2 until the "CAL" starts
flashing.
If the zero position alignment was
successfully performed, a check
mark is displayed.
If the check mark is not dis-
played:
Repeat alignment.
If the check mark is still not
displayed after repeating the
alignment, seek the advice of a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Installing height sensor
plugs
Remove the side panel
( 133).
6
97
z On the race track