Technical data

(Compression) is displayed at
position 4 "COM:".
To adjust rebound damping,
press buttons 1/2 until (DDC-
REAR) is displayed at pos-
ition 3 "DDC-RE" and (Re-
bound) is displayed at posi-
tion 4 "REB:".
Hold down button 2 until the
reading next to "REB:"/"COM:"
flashes.
Using buttons 1 and 2, adjust
damping as desired.
+1 .. +7: increase damping to
a maximum of seven levels
-1 .. -7: reduce damping to a
maximum of seven levels
0: default settings
Adjusting damping
characteristic for front
wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch to SETUP mode.
Without height sensor on the
front wheel:
To adjust damping, press
buttons 1/ 2 until (DDC-
FRONT) is displayed at
position 3 "DDC-FR" and
(Damping) is displayed at
position 4 "DMP:".
Press button 2 until the read-
ing next to "DMP:" flashes.
Using buttons 1 and 2, adjust
damping as desired.
+1 .. +7: increase damping to
a maximum of seven levels
-1 .. -7: reduce damping to a
maximum of seven levels
0: default settings
Without height sensor on the
front wheel:
To adjust compression damp-
ing, press buttons 1/ 2 until
(DDC-FRONT) is displayed
at position 3 "DDC-FR" and
(Compression) is displayed at
position 4 "COM:".
To adjust rebound damping,
press buttons 1/2 until (DDC-
FRONT) is displayed at po-
sition 3 "DDC-FR" and (Re-
6
96
z On the race track