Technical data

Remove protective cap from
connector 1 and connect level-
ing sensor connector.
In the SETUP menu damping
on the front wheel can be sep-
arately adjusted with respect
to rebound and compression
stage.
Installing fairing side panel
( 130).
Suspension
Height adjustment
In order to adjust the running
gear height, the link blocks 1
on the left and the right of the
spring strut bolting connection
can be replaced.
Two pairs of link blocks with dif-
ferent bore holes are enclosed
with the vehicle. As the blocks
can each be installed rotated by
180°, this results in five possi-
ble height adjustments using the
factory-installed blocks (-0.12 in
(-3 mm), -0.06 in (-1.5 mm),
0 in (0 mm), 0.06 in (+1.5 mm),
0.12 in (+3 mm)).
1 Link blocks with 0.12 in
(3 mm) bore hole outside the
center.
2 Link blocks with 0.06 in
(1.5 mm) bore hole outside
the center, this is the factory-
installed setting.
6
96
z On the racetrack