Technical data

Spring strut on the relay
lever
41 lb/ft (56 Nm)
Performing zero position align-
ment ( 95).
Launch control
Launchcontrol
Launchcontrol supports the rider
in maintaining the ideal speed for
a race start. Launchcontrol can
be activated in SLICK mode only.
After Launchcontrol is activated,
the system maintains the en-
gine speed at approx. 8000 rpm
at full throttle. After clutch en-
gagement, the speed is con-
trolled such that maximum trac-
tion is generated on the rear
wheel. Hereby, the throttle grip
remains in full-throttle position. If
a speed of 37 mph (60 km/h) is
exceeded, speed limiting is deac-
tivated.
While Launchcontrol is active, the
DTC system is deactivated.
Launchcontrol is also switched
off under the following condi-
tions:
Third gear is engaged.
Angle becomes greater than
30°.
Engine or ignition is switched
off.
Mode is changed.
The number of subsequent starts
with Launchcontrol is limited for
clutch protection. The number
of starts still possible is shown in
the display.
Race start with
Launchcontrol
Risk of injury due to
increased acceleration.
Launchcontrol allows maximum
acceleration, which could cause
unfamiliar riding situations.
Only use Launchcontrol on race
tracks.
Activate SLICK mode.
Bring vehicle in start position.
Vehicle is standing, engine is
running.
Press and hold the starter but-
ton 1 until the display changes.
Check display.
6
98
z On the racetrack