Technical data

Tighten screws 2 on the front
mudguard until hand-tight.
Threaded fasteners not
tightened to the specified
torque can work loose or their
threads can suffer damage.
Always have the security of the
fasteners checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
Tighten screws 1 for left and
right sliding tubes to the spe-
cified torque.
Fork bridge, bottom, with
slider tube
Tightening sequence: 2x
each side, alternately
25 Nm
If applicable, tighten quick-re-
lease axle 5 to the specified
torque.
Quick-release axle in axle
holder
50 Nm
If applicable, tighten axle
clamping screw 4 to the
specified torque.
Quick-release axle clamp
screws
19 Nm
Lower the motorcycle to the
ground and remove the lifter.
Work the engine spoiler
forward into position until
holders 3 on left and right
are seated on mounts 4 and
support it at the front.
5
79
z Operation