Technical data

Keep your hand clear of the trim
panel.
Pull the Bowden cable out of
holder 1.
Remove screws 2.
Disconnect plug 3.
Remove end of Bowden
cable 4 from the relay pulley.
Remove the control unit.
Remove diagnosis plug 1 from
its holder.
Disconnect plug 2 and remove
it from its holder.
Remove screw 3 and remove
battery holder 4.
Disconnection in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Disconnect negative battery
lead 5 first.
Then disconnect positive bat-
tery lead 6.
Lift the battery up and out.
Installing battery
Place the battery in the battery
compartment, positive terminal
on the left in the forward direc-
tion of travel.
Installation in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Never install the battery without
the protective cap.
Connect battery positive lead 6
first.
10
147
z Maintenance