Operation Manual

Charge the battery when
connected
Charging the connected
battery directly at the bat-
tery terminals can damage the
vehicle electronics.
Always disconnect the battery
from the on-board circuits be-
fore recharging it with a charger
connected directly to the battery
posts.
If you switch on the igni-
tion and the multifunction
display and indicator lights fail
to light up, the battery is com-
pletely flat (battery voltage is less
than 9 V). Attempting to charge
a completely flat battery via the
extra socket can cause damage
to the motorcycle's electronics.
If a battery has discharged to the
extent that it is completely flat, it
has to be disconnected from the
on-board circuits and charged
with the charger connected dir-
ectly to the battery posts.
With the battery connected
to the motorcycle's on-board
electrical system, charge only
via the power socket.
Comply with the operating in-
structions of the charger.
Charging battery when
disconnected
Charge the battery using a
suitable charger.
Comply with the operating in-
structions of the charger.
Once the battery is fully
charged, disconnect the
charger's terminal clips from
the battery terminals.
The battery has to be re-
charged at regular intervals
in the course of a lengthy period
of disuse. See the instructions
for caring for your battery. Al-
ways fully recharge the battery
before restoring it to use.
Removing battery
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
with anti-theft alarm
OE
If applicable, switch off the anti-
theft alarm.
Switch off the ignition.
Remove the centre trim panel
( 97).
Disengage large heat shield 1
from the battery.
8
95
z Maintenance