Operation Manual

Make sure the motorcycle is
standing firmly.
Fuses
Removing fuse
Any attempt to jumper a
defective fuse gives rise to
the risk of a short-circuit and fire.
Always replace a defective fuse
with a new fuse of the same
amperage.
Switch off the ignition.
Removing seat ( 38).
Squeeze latches 1 together
and remove the fuse cover.
Use the tool from the on-board
toolkit to pull the defective fuse
up and out of the fuse box.
If fuse defects recur fre-
quently have the electric
circuits checked by a specialist
workshop, preferably an author-
ised BMW Motorrad dealer.
Install the fuse
Replace the defective fuse with
a fuse of the correct amperage
rating.
The fuse assignments and
fuse amperage ratings spe-
cified for your motorcycle are lis-
ted in the section entitled "Tech-
nical data". The figures in the
graphic correspond to the fuse
numbers.
Close the fuse cover.
The latch engages with an
audible click.
Installing seat ( 39).
Lighting
Replacing bulbs for low-
beam and high-beam
headlight
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
8
85
z Maintenance