Operation Manual

swinging arm, the brake cal-
iper and the rear wheel.
Install axle nut 2, but do not
tighten it at this point.
Install the wheel-speed
sensor in the holder and
install screw 1, with washer, if
applicable.
Adjusting chain sag ( 76).
without centre stand
OE
Remove the auxiliary stand.
BMW Motorrad front-
wheel stand
Install the front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support the motorcycle
without the assistance of an
auxiliary stand. A motorcycle
resting only on the front wheel
stand and the rear wheel can
topple.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Place the motorcycle on a suit-
able auxiliary stand.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Use basic stand with tool num-
ber (83 30 0 402 241) in com-
bination with front-wheel ad-
apter (83 30 0 402 242).
Slacken securing screws 1.
Push the two adapters 2 apart
until the front forks fit between
them. Adjust the adapter studs
to suit the front suspension.
8
83
z Maintenance