Operation Manual

Hold the centre trim panel
in position and install oil dip-
stick 2.
Install screws 1 on left and
right, starting with the screws
in the middle.
Installing seat ( 39).
Removing right side panel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove the centre trim panel
( 97).
Remove screws 1 and 2.
Remove screw 3.
Pull the side panel at 4 out of
the mount and remove.
Installing right side panel
Insert the side panel into
mount 4.
Install screw 3.
8
98
z Maintenance