Operation Manual

Install screw 1.
Replacing rear-light and
brake-light bulb
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove two screws 1 and re-
move the rear-light glass.
Press bulb 2 into its socket
and turn it counter-clockwise to
remove.
Replace the defective bulb.
Bulb for tail light/brake
light
P25-2 / 12 V / 5 W / 21 W
Use a clean, dry cloth to hold
the new bulb in order to keep
the glass free of foreign matter.
Press bulb 2 into its socket
and turn it clockwise to install.
8
87
z Maintenance