Operation Manual

Insert the ABS sensor into its
bore and install screw 1. If
present, install the washer.
without centre stand
OE
Remove the auxiliary stand.
Removing rear wheel
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove screw 1 and remove
the wheel-speed sensor from
its holder; note that the screw
might be fitted with a washer.
Remove nut 2, counter-holding
at the left-hand side.
Slacken adjusting screws 3 on
left and right by turning them
counter-clockwise.
Remove quick-release axle 4,
supporting the rear wheel in
the process (for example slip a
wooden block of suitable thick-
ness underneath the wheel).
8
78
z Maintenance