Operation Manual

Fastener, quick-release
axle, front
45 Nm
Remove the front-wheel stand.
Apply the front brake and firmly
compress the front forks sever-
al times
Tighten axle clamping screw 2
to the specified torque.
Clamp, front quick-re-
lease axle
23 Nm
Insert the ABS sensor into its
bore and install screw 1.
without centre stand
OE
Remove the auxiliary stand.
Removing rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove two screws 1.
Remove three screws 2 and
remove the rear-wheel cover.
without centre stand
OE
Make sure the ground is level
and firm and place the mo-
8
79
z Maintenance