Operation Manual

Remove two screws 1.
Remove three screws 2 and
remove the rear-wheel cover.
without centre stand
OE
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove screw 1 of the speed
sensor and remove the speed
sensor from the holder.
Remove axle nut 2, counter-
holding at the left-hand side if
necessary.
Slacken adjusting screws 3 on
left and right by turning them
counter-clockwise.
8
80
z Maintenance