Technical data

0 °C, disengage the clutch after
switching on the ignition.
The start attempt is auto-
matically interrupted if bat-
tery voltage is too low. Recharge
the battery before you start the
engine, or use jump leads and a
donor battery to start.
The engine starts.
If the engine refuses to start,
consult the troubleshooting
chart in the section entitled
"Technical data". ( 116)
Press starter button 1.
If ambient temperatures are
very low, you might find it
necessary to open the throttle
slightly when starting the en-
gine. At ambient temperatures
below 32 °F (0 °C), disengage
the clutch after switching on the
ignition.
The start attempt is auto-
matically interrupted if bat-
tery voltage is too low. Recharge
the battery before you start the
engine, or use jump leads and a
donor battery to start.
The engine starts.
If the engine refuses to start,
consult the troubleshooting
chart in the section entitled
"Technical data". ( 116)
Pre-ride check
The instrument panel runs a test
of the instruments and the telltale
and warning lights when the ig-
nition is switched on: this is the
Pre-Ride-Check The test is abor-
ted if you start the engine before
it completes.
Phase 1
The rev. counter and speedo-
meter needles both swing to
the limit values on their scales.
At the same time, all the warn-
ing lights and telltale lights are
switched on in succession.
Phase 2
The 'General' warning light
changes from yellow to red.
Phase 3
The rev. counter and speedo-
meter needles both swing back
to rest. At the same time, all the
warning lights and telltale lights
switched on in the initial phase
are switched off in reverse se-
quence.
5
57
z Riding