Technical data

Install the right side panel
Begin by positioning the side
panel on retaining pin 4, then
swing it down and snap it into
mounts 5 and 6.
Install screw 3.
Install circlip 1.
Install the centre trim panel
( 105).
Jump starting
The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
vehicle electronics.
Do not use the on-board socket
to jump-start the engine of the
motorcycle.
A short-circuit can res-
ult if the crocodile clips
of the jump leads are accident-
ally brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the vehicle
electronics.
Make sure that the battery of the
donor vehicle has a voltage rating
of 12 V.
Remove the centre trim panel
( 104).
When jump-starting the engine,
do not disconnect the battery
from the on-board electrical
system.
8
106
z Maintenance