User Guide

11.18
11 12 116
Removing and installing cyl-
inder head, engine installed
e Attention:
If an engine failure occurs, the oil tank and oil lines
must be cleaned (a 11.17).
Preparatory work
– Remove the left, right, front and rear covers
(
a 46.6).
– Remove the stowage-compartment frame
(a 46.14).
– Disconnect battery.
– Remove exhaust with oxygen sensor (a 18.5).
– Drain coolant (
a 00.42).
•
Drain engine oil.
– Remove starter (
a 12.9).
– Expose radiator and remove fan (
a 17.12).
– Remove the intake air silencer together with the
intake air pipe (a 13.7).
•
Remove knurled nut securing throttle cable to
throttle flap stub and disengage the throttle cable
from the guide.
•
Disengage throttle cable from adapter.
•
Remove the intake stub from the cylinder head
and lay it carefully on the right-hand side, com-
plete with the throttle flap stub.
•
Disconnect the ignition coil from the spark plug.
•
Remove the fastener securing the ignition-coil
bracket and remove the ignition coil complete
with bracket.