User Guide

46.22
46 51 125 Removing and installing side
stand truss
– Place the motorcycle on the auxiliary stand,
BMW No. 00 1 620.
– Remove exhaust system (
a 18.5).
•
Remove cable cover on left-hand side of engine
block.
•
Disconnect plug of side-stand switch.
•
Release fasteners (1, 2).
•
Installation is the reverse of the removal proce-
dure.
X Tightening torque:
Side-stand truss to frame............................. 50 Nm
Engine shell to engine at bottom with truss .. 50 Nm
Exhaust elbow to cylinder head.................... 20 Nm
Clamp of silencer to exhaust elbow.............. 55 Nm
Silencer to rear frame................................... 41 Nm
46 53 000 Removing and installing side
stand
e Attention:
Note spring loading.
•
Use hook, BMWNo.465721, to disengage
springs (3). Remove plate (6) with the springs.
•
Remove keeper (1).
•
Remove switch (2).
•
Remove screw (5).
•
Remove stand (4).
•
Installation is the reverse of the removal proce-
dure.
e Attention:
Install screw with Loctite 243.
Lubricant:
for bearing bushing ........... Staburags NBU 30 PTM
X Tightening torque:
Side stand to bottom truss........................... 41 Nm
K14460250
2
1
3
4
K14460340
5
6
1
2