Operation Manual

Use a screwdriver to push the
chain up and down and meas-
ure difference A.
Chain deflection
30...40 mm (Motorcycle with
no weight applied, supported
on its side stand)
with lowered suspension
OE
20...30 mm (Motorcycle with
no weight applied, supported
on its side stand)
If measured value is outside per-
mitted tolerance:
Adjust chain sag ( 114).
Adjust chain sag
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Slacken quick-release axle
nut 1.
Slacken locknuts 2 on left and
right.
Use adjusting screws 3 on left
and right to adjust chain sag.
Check chain sag ( 113).
Make sure that scale read-
ings 4 are the same on left and
right.
Tighten locknuts 2 on left and
right to the specified tightening
torque.
Locknut of the final-drive
chain tensioning screw
19 Nm
Tighten quick-release axle
nut 1 to the specified tight-
ening torque.
Rear quick-release axle
in swinging arm
100 Nm
Checking the chain wear
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Engage 1st gear.
9
114
z Maintenance