Operation Manual

To make different adjustment to
the damping:
Repeatedly press button 1 until
the setting you want to use
appears on the display.
You can adjust the damping
characteristic while the mo-
torcycle is on the move.
The setting shown on the dis-
play is automatically accepted
as the damping characteristic
if you allow a certain length of
time to pass without pressing
button 1.
The ESA indicator disappears
from the display as soon as
adjustment completes.
Tyres
Checking tyre pressure
Incorrect tyre pressures im-
pair the motorcycle's hand-
ling characteristics and increase
the rate of tyre wear.
Always check that the tyre pres-
sures are correct.
At high road speeds, tyre
valves installed perpendicu-
lar to the wheel rim have a tend-
ency to open.
In order to avoid sudden defla-
tion, fit valves installed perpen-
dicular to the rim with valve caps
complete with rubber seals and
make sure the valve caps are
screwed firmly on to the valves.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Check tyre pressures against
the data below.
Tyre pressure, front
2.2 bar (one-up, tyre cold)
2.2 bar (two-up and/or with
luggage, tyre cold)
Tyre pressure, rear
2.5 bar (one-up, tyre cold)
2.9 bar (two-up and/or with
luggage, tyre cold)
If tyre pressure is too low:
Correct tyre pressure.
Headlight
Adjusting headlight for
driving on left/driving on
right
If the motorcycle is ridden in a
country where the opposite rule
of the road applies, its asymmet-
ric low-beam headlight will tend
to dazzle oncoming traffic.
Have the headlight set
accordingly by a specialist
workshop, preferably an
authorised BMW Motorrad
dealer.
4
56
z Operation