Operation Manual

duction in spring preload re-
quires softer damping.
Adjust the damping for
rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Adjust the damping charac-
teristic by turning adjusting
screw 1.
If you want a harder damping
characteristic, turn adjusting
screw 1 in the direction indic-
ated by the H arrow.
If you want a softer damping
characteristic, turn adjusting
screw 1 in the direction indic-
ated by the S arrow.
Basic setting of rear-sus-
pension damping charac-
teristic
without Electronic Suspen-
sion Adjustment (ESA)
OE
Basic setting of rear-sus-
pension damping charac-
teristic
Turn the adjusting screw as
far as it will go in the clock-
wise direction and then back
it off one and a half turns
(One-up without luggage)
Turn the adjusting screw as
far as it will go in the clock-
wise direction and then back
it off one and a half turns
(One-up with luggage)
Turn the adjusting screw as
far as it will go in the clock-
wise direction and then back
it off 1 turn (Two-up with
luggage)
4
54
z Operation