Operation Manual

+ "--" or "-- --" ap-
pears on the display.
Possible cause:
The vehicle has not yet
accelerated past the threshold of
approximately 30 km/h. The RDC
sensors do not start transmitting
signals until the motorcycle
reaches a speed above this
threshold ( 79).
Increase speed above this
threshold and observe the RDC
readings. Assume that a per-
manent fault has not occurred
unless the 'General' warning
light comes on to accompany
the symptoms. Under these
circumstances:
Have the fault rectified by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Possible cause:
Wireless communication with the
RDC sensors has been disrupted.
Possible causes include radio-
communication systems operat-
ing in the vicinity and interfering
with the link between the RDC
control unit and the sensors.
Move to another location and
observe the RDC readings. As-
sume that a permanent fault
has not occurred unless the
'General' warning light comes
on to accompany the symp-
toms. Under these circum-
stances:
Have the fault rectified by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
Sensor defective or
system error
with tyre pressure monitoring
(RDC)
OE
General warning light shows
yellow.
+ "--" or "-- --" ap-
pears on the display.
Possible cause:
Motorcycle is fitted with wheels
not equipped with RDC sensors.
Fit wheels and tyres equipped
with RDC sensors.
Possible cause:
1 or 2 RDC sensors have failed.
Have the fault rectified by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.
3
37
z Status indicators