Operation Manual

Remove air filter 3.
Installing air filter
Install air filter 3.
Put on the air filter cover 2,
slightly pushing the side trim
panel outwards to do so.
Install screws 1 with the wash-
ers.
Installing centre trim panel
( 117).
Jump starting
The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
vehicle electronics.
Do not use the on-board socket
to jump-start the engine of the
motorcycle.
A short-circuit can res-
ult if the crocodile clips
of the jump leads are accident-
ally brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the vehicle
electronics.
Make sure that the battery of the
donor vehicle has a voltage rating
of 12 V.
Removing centre trim panel
( 116).
When jump-starting the engine,
do not disconnect the battery
from the on-board electrical
system.
8
118
z Maintenance