Operation Manual

to the edge 3 of the manual
valve.
Clutch cable play
5 mm (Handlebars are in
straight-ahead position)
Clutch play is out of tolerance:
Adjusting clutch play ( 100).
Adjusting clutch play
Move the rubber grommet 1 to
one side.
Slacken nut 2.
To increase clutch play: Screw
the adjusting screw 3 into the
manual valve.
To reduce clutch play: Un-
screw the adjusting screw 3
from the manual valve.
Check the clutch play ( 99).
Tighten nut 2 while holding the
adjusting screw 3 in position.
Fasten the rubber grommet 1
over the nuts.
Rims and tyres
Checking rims
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Visually inspect the rims for
defects.
Have any damaged rims in-
spected by a specialist work-
shop and replaced if neces-
sary, preferably by an author-
ised BMW Motorrad dealer.
Check the tyre tread
depth
Your motorcycle's handling
and grip can be impaired
even before the tyres wear to
the minimum tyre tread depth
permitted by law.
Have the tyres changed in good
time before they wear to the
minimum permissible tread
depth.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Measure the tyre tread depth
in the main tread grooves with
wear marks.
Tyres have wear indicators
integrated into the main
tread grooves. The tyre is worn
out when the tyre tread has worn
down to the level of the marks.
The locations of the marks are
indicated on the edge of the tyre,
8
100
z Maintenance