Operation Manual

Install nut 2, but do not tighten
it at this point.
without centre stand
OA
Remove the auxiliary stand.
Insert the speed sensor into
the bore and install screw 1.
Adjust the chain sag ( 101).
Front-wheel stand
Installing front wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support the motorcycle
without the assistance of an
auxiliary stand. A motorcycle
resting only on the front wheel
stand and the rear wheel can
topple.
Place the motorcycle on an aux-
iliary stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Place the motorcycle on a suit-
able auxiliary stand.
with centre stand
OE
Place the motorcycle on its
centre stand.
Use basic stand (0 402 241)
with front-wheel adapter
(0 402 242).
Slacken adjusting screws 1.
Push the two adapters 2 apart
until the front forks fit between
them. Adjust the adapter studs
to suit the front suspension.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
8
108
z Maintenance