Operation Manual

Remove the rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Remove screw 1 and remove
the speed sensor from its bore.
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
with centre stand
OA
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove axle nut 2.
Slacken locknuts 3 on left and
right by turning them counter-
clockwise.
Back off adjusting screws 4 on
left and right by turning them
counter-clockwise.
Remove adjusting plate 5 and
push the axle in as far as it will
go.
Remove quick-release axle 6
and remove adjusting plate 7.
Roll the rear wheel as far for-
ward as possible and disen-
gage chain 8 from the sprock-
et.
8
106
z Maintenance