Operation Manual

Firmly compress the front forks
several times.
Tighten axle clamping screw 2
to the specified torque.
Clamp of quick-release
axle
19 Nm
with BMW Motorrad ABS
OE
Insert the ABS sensor into its
bore and install screw 1.
The cable of the ABS
sensor could chafe through
if it comes into contact with the
brake disc.
Make sure that the ABS sensor
cable is routed correctly.
Make sure that the ABS sensor
cable is routed as shown
here.
Remove the auxiliary stand, if
installed beforehand.
Removing rear wheel
Place the motorcycle on a suit-
able auxiliary stand.
with centre stand
OE
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Remove screw 1 of the speed
sensor and remove the speed
sensor from the holder.
Remove axle nut 2.
8
104
z Maintenance