Operation Manual

Step 2:
No function allocated to this step.
Press button 1 or button 2.
Step 3: Which alarm tone
would you like the alarm to
sound?
Rising and falling:
Press button 1.
Intermittent:
Press button 2.
Step 4: Do you want to have
the alarm function activated
automatically when you switch
off the ignition?
Yes:
Press button 1.
No:
Press button 2.
Under what
circumstances is
programming aborted?
Programming is aborted
if the ignition is switched off
before completion of the last
step in the programming se-
quence.
or automatically if more than
30 seconds are allowed to
elapse between any two con-
secutive steps in the program-
ming routine.
The new settings are not saved if
programming is aborted.
Saving programming
Programming is saved
if the ignition is switched off
after completion of the last
step in the programming se-
quence
or automatically 30 seconds
after completion of the last
step in the programming
routine
The anti-theft alarm status indic-
ator light stops flashing and four
acknowledgement tones sound.
Registration of the
remote control
with anti-theft alarm (DWA)
OE
When is it necessary to
register a remote control?
If you want to register an addi-
tional remote control or register
a remote control as a replace-
ment for one that has been mis-
laid, you must always register all
the remote control units with the
anti-theft alarm. You can register
a maximum of four remote con-
trol units.
5
59
z Anti-theft alarm DWA