Technical information

1. Place material under the vehicle floor to prevent the base from caving in.
2. Carry out glass management (including cutting through the front windscreen horizontally in area 2 or 3 ).
3. Use hydraulic shears to cut off door at its hinges.
4. Use hydraulic shears to cut through the side sill 1 in front of the occupant towards the floor.
5. Use hydraulic shears to cut through both A-pillars in the lower section 2 or in the upper section 3.
6. Attach support angle to the B-pillar as shown.
Note:
If the emergency cylinder is too short, insert the support angle horizontally.
7. Where possible, insert the emergency cylinder between the central mounting and the dashboard.
8. Push the front end away.
Forcing dashboard forwards
Version 2
Important!
Danger of injury!
Emergency equipment may slip or slide.
Page
7
of
66
<!
----
>
2/24/2015
file://C:\Users\QX54891\AppData\Local\Temp\14\DW_Temp_QX54891\VUL
-
REL
-
BM
...