Technical information

.
In the next step, the voltage of each of the two contacts to the housing of the electrical machine electronics is measured.
The housings of all high-voltage components are connected via GND by means of potential compensation lines. If a high-
voltage potential is present at the housing and/or at GND due to damage, it can be measured with this procedure.
.
If no voltage is measured at any time, one can assume that the system is no source of danger.
.
10. Installing the high-voltage connector
In order to rule out further improper treatment, install and lock the high-voltage connector again. The smaller connector
(HV interlock) must not be installed again.
Page
63
of
66
<!
----
>
2/24/2015
file://C:\Users\QX54891\AppData\Local\Temp\14\DW_Temp_QX54891\VUL
-
REL
-
BM
...